Table of Contents
Advertisement
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the node is installed in an enclosure or mounted, remove the node from the enclosure or mount. See
"Configuration guide" on page
Procedure
Step 1.
Make preparation for this task.
a.
Remove the top cover. See
b.
Remove the PMB air baffle. See
c.
Lift the riser assembly from the node. See
228.
d.
Depending on the model, remove the PMB side SMA assembly or SMA filler. See
SMA assemblies" on page
e.
To ensure sufficient space for this task, place the signal cable that connects the front operator
panel and rear operator panel outside of the chassis.
Figure 152. Placing the signal cable
Step 2.
Loosen the screws that secure the two grounding cables to disconnect the cables from
and
internal power supply unit.
2
ThinkEdge SE360 V2 User Guide
152
and
"Safety inspection checklist" on page 48
54.
54.
"Remove the top cover" on page
"Remove the PMB air baffle" on page
"Remove the riser assembly from the node" on page
300.
to ensure that you
197.
107.
"Remove the
1
chassis
Advertisement
Table of Contents
Troubleshooting
