a.
Push the intrusion switch toward the chassis and align the opening of the bracket with the
guide pin; then, slide the intrusion switch toward the guide pin until it stops.
b.
Secure the intrusion switch with one screw.
Figure 166. Installing intrusion switch with cable
Step 3.
Connect the intrusion switch cable to the system board.
Figure 167. Top intrusion switch cable routing
Intrusion switch connector on the system board
1
After this task is completed
Complete the parts replacement. See
Demo Video
Watch the procedure on YouTube
Remove the bottom intrusion switch with cable
Follow instructions in this section to remove the bottom intrusion switch with cable.
About this task
ThinkEdge SE360 V2 User Guide
162
"Complete the parts replacement" on page
324.