Table of Contents
Advertisement
b.
Lower the I/O module board down until it is firmly seated.
c.
Secure the I/O module board with six screws.
Figure 180. Installing the I/O module board
Step 2.
Connect the cables to the I/O module board.
a.
Twist the I/O-board signal cable as shown; then, connect the signal cable and the power cable
to the I/O module board.
Figure 181. Connecting the I/O-board cables
b.
Reconnect all the required cables to the same connectors on the I/O module board as the
defective I/O module board.
Install an M.2 drive
If necessary, install an M.2 drive to the I/O module board.
Step 1.
Locate the slot to install the M.2 drive.
Note: The slots are numbered to indicate the installation order. If only one M.2 drive is to be
installed to the I/O module board, install the M.2 drive in Slot 1.
.
Chapter 5
Hardware replacement procedures
175
Advertisement
Table of Contents
Troubleshooting
