Figure 176. I/O-board cable routing
Cable clips
1
Step 4.
Remove the top cover. See
Step 5.
Remove the riser assembly. (Before disconnecting the cables of riser assembly, remove the
processor air baffle.) See
the processor air baffle and air flow sensor board" on page
Step 6.
Route the I/O-board power cable and signal cable through the chassis hole to the top side of the
node.
Step 7.
Disconnect the I/O-board power cable and signal cable from the system board; then, remove the
cables from the chassis.
"Remove the top cover" on page
"Remove the riser assembly from the node" on page 228
Mylar film
2
197.
110.
.
Chapter 5
Hardware replacement procedures
and
"Remove
171