Lenovo ThinkEdge SE360 V2 User Manual page 40

1. Before you change any switch settings or move any jumpers, turn off the server; then, disconnect all
power cords and external cables. Review the following information:
•
https://pubs.lenovo.com/safety_documentation/
• "Installation Guidelines" on page 47
• "Handling static-sensitive devices" on page 50
• "Power off the server" on page 54
2. Any system-board switch or jumper block that is not shown in the illustrations in this document are
reserved.
Figure 14. System-board switches
The following table describes the functions of the switches on the system board.
Table 10. System-board switches
Switches Switch
block number
1
2
3
4
SW1
1
5
6
7
8
ThinkEdge SE360 V2 User Guide
30
Switch name
XClarity Controller The node boots by using a
backup of the XCC firmware
boot backup
CMOS clear Clears the real-time clock (RTC)
registry
Password override
Overrides the power-on password
(Reserved) (Reserved)
XCC COM port Enables XCC connection to the
serial port
Machine Engine (ME) ME boots to recovery
recovery override
(Reserved) (Reserved)
(Reserved) (Reserved)
Usage description
On
Normal (default)
Normal (default)
Normal (default)
Normal (default)
Normal (default)
Normal (default)
Normal (default)
Normal (default)
Off