Table of Contents
Advertisement
For the configuration with full-height PCIe adapter
Step 2.
Proceed to the section corresponding to the configuration:
• To install the processor air baffle without air flow sensor board, see
baffle" on page
• To install the processor air baffle and the air flow sensor board, see
baffle and the air flow sensor board" on page
Install the processor air baffle
Step 1.
Gently pinch the air baffle as shown, and align the air baffle tabs with the slots on the chassis.
Step 2.
Lower the air baffle into the chassis until it is seated in place.
Figure 109. Installing the air baffle
Install the processor air baffle and the air flow sensor board
Step 1.
Make sure that all installed fan modules are with rear-to-front air flow direction. If applicable, install
fan modules with rear-to-front air flow direction. See
Step 2.
Connect the cable to the air flow sensor board.
Step 3.
Install the air flow sensor board to the processor air baffle.
a.
Align the air flow sensor board with the processor air baffle; then, lower the air flow sensor
board to the air baffle.
115.
For the configuration without full-height PCIe
adapter
"Install the processor air
"Install the processor air
115.
"Install a fan module" on page
.
Chapter 5
Hardware replacement procedures
146.
115
Advertisement
Table of Contents
Troubleshooting
