Lenovo ThinkEdge SE360 V2 User Manual page 138

CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the node is installed in an enclosure or mounted, remove the node from the enclosure or mount. See
"Configuration guide" on page
• If one or more NVMe solid-state drives are to be removed, it is recommended to disable them beforehand
via the operating system.
• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board), drive backplanes, or drive cables, make sure to back up all important data stored in
drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Procedure
Step 1. Make preparation for this task.
a. Remove the bottom cover. See
b. Remove the bottom air baffle. See
Remove an M.2 drive
If necessary, remove an M.2 drive from the bottom M.2 cabled adapter.
Step 1. Locate the M.2 drive to be removed.
Slots on bottom M.2 cabled adapter
ThinkEdge SE360 V2 User Guide
128
and "Safety inspection checklist" on page 48
54.
54.
"Remove the bottom cover" on page
"Remove the bottom air baffle" on page
to ensure that you
201.
105.