Lenovo ThinkEdge SE360 V2 User Manual page 241

Remove components from the left wing of riser assembly
Follow instructions in this section to remove components from the left wing of riser assembly.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the node is installed in an enclosure or mounted, remove the node from the enclosure or mount. See
"Configuration guide" on page
Procedure
Step 1. Make preparation for this task.
a. If applicable, remove all the 7mm drives. See
b. Remove the top cover. See
c. Remove the PMB air baffle. See
d. Remove the riser assembly. (Before disconnecting the cables of riser assembly, remove the
processor air baffle.) See
"Remove the processor air baffle and air flow sensor board" on page
Step 2. Proceed to the section corresponding to the component to be removed:
• "M.2 assembly" on page 231
• "PCIe assembly" on page 234
• "Drive backplanes" on page 235
• "PCIe assembly + geotracking module" on page 236
Remove M.2 assembly
Procedure
Step 1. Remove the M.2 cabled adapter from the riser cage.
a. Disconnect the signal cable from the M.2 cabled adapter. Disconnect
then, disconnect
and "Safety inspection checklist" on page 48
54.
54.
"Remove the top cover" on page
"Remove the PMB air baffle" on page
"Remove the riser assembly from the node" on page 228
MCIO 1 connector
1
"Remove a 7mm hot-swap drive" on page
197.
.
Chapter 5 Hardware replacement procedures
to ensure that you
100.
107.
and
110.
MCIO 2 connector;
2
231