Figure 296. I/O-board cable routing
I/O-board power cable
1
Step 4.
Peel away the XClarity Controller network access label on the processor heat sink and attach it to
the network access tag on the front of the server.
Figure 297. Lenovo XClarity Controller network access label on the pull-out information tab
After this task is completed
1. The I/O-board power cable and signal cable should be routed to the bottom side of the node to connect
to the I/O module board. See
2. Reconnect all the required cables to the same connectors on the system board as the defective system
board.
"Install the I/O module board and M.2 boot drives" on page
I/O-board signal cable
2
.
Chapter 5
Hardware replacement procedures
172.
279