Lenovo ThinkEdge SE360 V2 User Manual page 222

Step 2. Carefully pinch and hold the connector of the RJ-45 UART cable; then, push the PIB module
outwards to remove it from the chassis.
Figure 222. Removing the DC PIB module
After this task is completed
• Install a replacement unit. See
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Remove the AC PIB module
Procedure
Step 1. Loosen the screw that secures the PIB module.
Step 2. Carefully pinch and hold the power connector; then, push the PIB module outwards to remove it
from the chassis.
Figure 223. Removing the AC PIB module
After this task is completed
• Install a replacement unit. See
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the PIB module
Follow instructions in this section to install the power input board (PIB) module.
ThinkEdge SE360 V2 User Guide
212
"Install the PIB module" on page
"Install the PIB module" on page
212.
212.