Table of Contents
Advertisement
Figure 34. The screw on the enclosure to be removed
b.
To install the enclosure to the rail kit except for ThinkEdge 600mm Ball Bearing Rail Kit,
remove the screw which is the closest to the rear of the enclosure; one for each side, total two
screws should be removed.
Figure 35. The screw on the enclosure to be removed
Step 4.
Install the inner rails to the enclosure.
Attention: There are "L" and "R" logos marked on the front of inner rails which represent the left
rail and the right rail. Ensure correct rails are installed to the rack accordingly.
a.
Remove the two screws from the side of the enclosure; save the screws for later use.
b.
Align the mounting holes on the inner rail with the corresponding rail mounting pins on the side
of the enclosure.
c.
Push the inner rail as shown until the mounting pins on the enclosure are locked in place.
d.
Tighten the two screws to secure the inner rail to the enclosure.
e.
Repeat this procedure to install the other inner rail.
.
Chapter 5
Hardware replacement procedures
63
Advertisement
Table of Contents
Troubleshooting
