A video of this procedure is available at YouTube:
AooAU9z6S2EXObfHoLImDm
Procedure
Step 1.
Make preparation for this task.
a.
Remove the top cover. See
b.
Remove the PMB air baffle. See
c.
Lift the riser assembly from the node. See
228.
d.
Remove the wireless adapter. See
Step 2.
Locate the WLAN/Bluetooth module to be removed.
x86 WLAN module (with two cable connectors)
1
Step 3.
Pinch and press the side of the cable holder; then, lift up one end of the cable holder from the
wireless adapter.
Figure 302. Lifting the cable holder
Step 4.
Pivot the cable holder to
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Remove the top cover" on page
"Remove the PMB air baffle" on page
"Remove the wireless adapter" on page
unlock position.
2
197.
"Remove the riser assembly from the node" on page
XCC WLAN and Bluetooth module (with three
2
cable connectors)
.
Chapter 5
Hardware replacement procedures
107.
285.
289