Table of Contents
Advertisement
Step 4.
Loosen the four M4 screws and four M6 screws that secure the wall-mount plate; then, remove the
wall-mount plate from the wall.
Figure 49. Removing the wall-mount plate
Step 5.
If applicable, remove the WLAN antennas. See
Step 6.
If applicable, turn the screw between the two SMA connectors clockwise to shorten the connectors
into the chassis.
Note: Make sure that the SMA connectors are shortened into the chassis; if the SMA connectors
are extended and out of the chassis, the node can not be removed successfully.
Figure 50. Shortening the SMA connectors
ThinkEdge SE360 V2 User Guide
72
"Remove the WLAN antennas" on page
299.
Advertisement
Table of Contents
Troubleshooting
