CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the node is installed in an enclosure or mounted, remove the node from the enclosure or mount. See
"Configuration guide" on page
Procedure
Step 1.
Make preparation for this task.
a.
Remove the top cover. See
b.
Remove the PMB air baffle. See
c.
Lift the riser assembly from the node. See
228.
Step 2.
Locate the MicroSD socket on the system board. See
Step 3.
Remove the MicroSD card.
a.
Slide the socket lid to the open position.
b.
Lift open the socket lid.
c.
Remove the MicroSD card from the socket.
and
"Safety inspection checklist" on page 48
54.
54.
"Remove the top cover" on page
"Remove the PMB air baffle" on page
"Remove the riser assembly from the node" on page
197.
107.
"System-board connectors" on page
.
Chapter 5
Hardware replacement procedures
to ensure that you
28.
195