Power Off The Server; Configuration Guide - Lenovo ThinkEdge SE360 V2 User Manual

Power off the server

The server remains in a standby state when it is connected to a power source, allowing the Lenovo XClarity
Controller to respond to remote power-on requests. To remove all power from the server (power status LED
off), you must disconnect all power cables.
Power button location and power LED are specified in:
• Chapter 2 "Server components" on page 19
• "Troubleshooting by system LEDs" on page 373
To place the server in a standby state (power status LED flashes once per second):
Note: The Lenovo XClarity Controller can place the server in a standby state as an automatic response to a
critical system failure.
• Start an orderly shutdown using the operating system (if supported by your operating system).
• Press the power button to start an orderly shutdown (if supported by your operating system).
When in a standby state, the server can respond to remote power-on requests sent to the Lenovo XClarity
Controller. For information about powering on the server, see

Configuration guide

Follow instructions in this section to remove and install supporting mounting configurations.
ThinkEdge SE360 V2 node is designed to support the following mounting options:
• Desktop mount: The node is oriented horizontally with rubber feet installed at the bottom side. For the
locations and replacement of rubber feet, see
• Rack mount: Up to two nodes can be installed to an enclosure, and the enclosure can be installed to the
rack. See "Rack mount configuration" on page
• Wall mount/ceiling mount: With node sleeve, the node can be mounted on the wall or the ceiling. See
"Wall mount/ceiling mount configuration" on page
• DIN-rail mount: With node sleeve and DIN rail clips, the node can be mounted on a DIN rail. See
configuration" on page
Important: The mounting options of SE360 V2 support different system configuration. For proper operation,
see the following table for the supported configurations:
Table 15. Supported configurations of SE360 V2 mounting options
• Wireless module
Electrical input
• 300W external power
adapter*
• DC power source input
• AC power source input
ThinkEdge SE360 V2 User Guide
54
"Rubber feet replacement" on page
84.
Desktop mount
√
√
√
√
"Power on the server" on page
55.
69.
Rack mount
Wall mount/
ceiling mount
√
√ √
√ √
53.
269.
"DIN rail
DIN-rail mount
√
√
√