Lenovo ThinkEdge SE360 V2 User Manual page 15

Expansion slots
Supported expansion slots vary by model.
• Slot 1 to 2 (I/O module board): NVMe Gen3 x1 M.2 boot drives
• Slot 3 (Left wing of riser assembly) supports one of the following:
– One PCIe Gen4 x16 FH/HL adapter
– One PCIe Gen4 x16 HH/HL adapter
– One NVMe Gen4 x4 M.2 storage drive
• Slot 4 to 6 (Left wing of riser assembly): NVMe Gen4 x4 M.2 storage drives
• Slot 7 (Right wing of riser assembly) supports one of the following:
– One PCIe Gen4 x16 HH/HL adapter
– One NVMe Gen4 x4 M.2 storage drive
• Slot 8 to 10 (Right wing of riser assembly): NVMe Gen4 x4 M.2 storage drives
• Slot 11 to 12 (Bottom M.2 cabled adapter): NVMe Gen3 x4 M.2 storage drives
Note: When Slot 3 to 6 support M.2 storage drives, Slot 11 to 12 are disabled.
Graphics processing unit (GPU)
Supports up to two low-profile PCIe GPU adapters
Integrated functions and I/O connectors
• Lenovo XClarity Controller (XCC), which provides service processor control and monitoring functions, video
controller, and remote keyboard, video, mouse, and remote drive capabilities.
– The server supports Lenovo XClarity Controller 2 (XCC2). For additional information about Lenovo XClarity
Controller 2 (XCC2), refer to
• Front I/O connectors
Note: The slot for Bluetooth antenna is on the front of the server. For the models without wireless module, install
the Bluetooth antenna filler to the corresponding slot for proper operation. The Bluetooth antenna filler is in the
material box. See "Front view" on page 19
– One XCC system management port on the front to connect to a systems-management network. This RJ-45
connector is dedicated to the Lenovo XClarity Controller functions and runs at 1 GB speed.
– Two USB 3.2 Gen 1 (5 Gbps) Type-A connectors
– One USB 3.2 Gen 1 (5 Gbps) Type-C connector with display support
– One USB 2.0 Type-C connector with Lenovo XClarity Controller management
– Two 2.5GbE RJ-45 connectors
– Depending on the model, one of the following groups of Ethernet connectors:
– With 10/25GbE I/O module board installed: four 10/25GbE SFP28 connectors
Note: The transmission speed of SFP28 connectors could be 10 Gbps or 25 Gbps, depending on the
processor selected. Processors with at least 16 cores support transmission speed of 25 Gbps.
– With 1GbE I/O module board installed: four 1GbE RJ-45 connectors
• Rear I/O connector
– One RJ-45 RS-232 serial console connector
https://pubs.lenovo.com/lxcc-overview/
to locate the Bluetooth antenna filler.
.
Chapter 1
.
Introduction
5