Table of Contents
Advertisement
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1.
Install the front operator panel.
a.
Insert the front operator panel into the slot.
b.
Secure the front operator panel with two screws on the front.
Figure 151. Installing the front operator panel
Step 2.
Connect the cables to the front operator panel. See
After this task is completed
Complete the parts replacement. See
Demo Video
Watch the procedure on YouTube
ThinkEdge SE360 V2 User Guide
150
and
"Safety inspection checklist" on page 48
"Operator panel cable routing" on page
"Complete the parts replacement" on page
to ensure that you
337.
324.
Advertisement
Table of Contents
Troubleshooting
