Step 2.
Place a washer between the chassis and the screw nut if necessary; then, fasten the screw nut with
the wrench to secure the Bluetooth antenna.
Figure 124. Installing the Bluetooth antenna
Note: The optional kit of antenna comes with a washer. However, the washer is an optional part
that enhances friction, and is not required in general scenarios. Consider applying it when
necessary.
Step 3.
Connect the Bluetooth antenna cable to the wireless adapter.
a.
Pinch and press the side of the cable holder on the XCC WLAN and Bluetooth module; then, lift
up one end of the cable holder from the wireless adapter.
Figure 125. Lifting the cable holder
b.
Pivot the cable holder to
ThinkEdge SE360 V2 User Guide
124
unlock position.
2