Table of Contents
Advertisement
Step 1.
If applicable, remove the WLAN antennas. See
Step 2.
If applicable, turn the screw between the two SMA connectors clockwise to shorten the connectors
into the chassis.
Note: Make sure that the SMA connectors are shortened into the chassis; if the SMA connectors
are extended and out of the chassis, the node can not be installed successfully.
Figure 78. Shortening the SMA connectors
Step 3.
Loosen the eight screws that secure the two side brackets (four for each side bracket) to
disassemble the node bracket.
Figure 79. Disassembling the node bracket
Step 4.
Depending on the model, fasten four screws or thumbscrews to secure one side bracket to the
node; then, repeat the procedure to the other side bracket.
Note: There are "L" and "R" logos marked on the front of side brackets which represent the left
bracket and the right bracket (viewed from the front of the node). Make sure to install the brackets
with correct orientation shown in the illustration.
ThinkEdge SE360 V2 User Guide
90
"Remove the WLAN antennas" on page
299.
Advertisement
Table of Contents
Troubleshooting
