Table of Contents
Advertisement
x86 WLAN module (with two cable connectors)
1
Step 2.
If applicable, remove the dummy cover from the WLAN/Bluetooth module slot.
a.
Press the retainer to disengage the cover.
b.
Lift up the front end of the cover at an angle.
c.
Remove the cover from the slot.
Figure 306. Removing the dummy cover
Step 3.
If applicable, remove the film from the thermal pad on the wireless adapter.
Figure 307. Removing the film from thermal pad
Step 4.
Install the WLAN/Bluetooth module.
a.
Insert the WLAN/Bluetooth module into the slot at an angle.
b.
Press the WLAN/Bluetooth module down until it clicks into place.
ThinkEdge SE360 V2 User Guide
292
XCC WLAN and Bluetooth module (with three
2
cable connectors)
Advertisement
Table of Contents
Troubleshooting
