Lenovo ThinkEdge SE360 V2 User Manual page 183

• Read "Installation Guidelines" on page 47
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
The following notes describe the type of drives that the server supports and other information that you must
consider when you install a drive. For a list of supported drives, see
• Locate the documentation that comes with the drive and follow those instructions in addition to the
instructions in this chapter.
• For a complete list of supported optional devices for the server, see
• SE360 V2 supports up to two 80mm (2280) NVMe M.2 boot drives.
Install the I/O-board power and signal cable
If necessary, route the I/O-board power cable and signal cable.
Procedure
Step 1. If applicable, remove the top cover. See
the node facing up.
Step 2. If applicable, remove the riser assembly. See
228.
Step 3. Connect the I/O-board power cable and signal cable to the system board; then, route the cables
through the chassis hole to the bottom side of the node.
Note: Make sure to route the I/O-board power cable between the standoff and the chassis as
shown.
Figure 178. I/O-board cable routing
I/O-board power cable
1
Step 4. Reinstall the riser assembly to the node. See
Step 5. Let the bottom side of the node facing up.
Step 6. Pull up the Mylar film.
and "Safety inspection checklist" on page 48
https://serverproven.lenovo.com
"Remove the top cover" on page
"Remove the riser assembly from the node" on page
I/O-board signal cable
2
"Install the riser assembly to the node" on page
Chapter 5
to ensure that you
https://serverproven.lenovo.com
197. Let the top side of
.
Hardware replacement procedures
.
.
259.
173