Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the node is installed in an enclosure or mounted, remove the node from the enclosure or mount. See
"Configuration guide" on page
Procedure
Step 1.
Make preparation for this task.
a.
Remove the top cover. See
b.
Remove the PMB air baffle. See
c.
Lift the riser assembly from the node. See
228.
Step 2.
Disconnect all the cables from the front operator panel.
Step 3.
Remove the front operator panel.
a.
Loosen the two screws on the front.
b.
Remove the front operator panel from the slot.
Figure 150. Removing the front operator panel
After this task is completed
• Install a replacement unit. See
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo Video
Watch the procedure on YouTube
Install the front operator panel
Follow instructions in this section to install the front operator panel.
and
"Safety inspection checklist" on page 48
54.
54.
"Remove the top cover" on page
"Remove the PMB air baffle" on page
"Remove the riser assembly from the node" on page
"Install the front operator panel" on page
197.
107.
149.
.
Chapter 5
Hardware replacement procedures
to ensure that you
149