Note: Make sure that the WLAN/Bluetooth module is firmly secured by the retainer. If the
retainer does not engage with the module, press the retainer and adjust the module until the
module is firmly secured.
Figure 308. Installing the WLAN/Bluetooth module
Step 5.
Install the WLAN/Bluetooth module heat sink.
a.
Remove the film from the thermal pad on the heat sink.
Figure 309. Removing the film from thermal pad
b.
Align the heat sink with the slots on the wireless adapter; then, lower the heat sink until it is
firmly seated.
c.
Tighten the two captive screws to secure the heat sink.
.
Chapter 5
Hardware replacement procedures
293