Lenovo ThinkEdge SE360 V2 User Manual page 245

Figure 247. Removing the PCIe adapter
Step 2. Disconnect all the cables from the PCIe cabled riser card.
Step 3. Remove the PCIe cabled riser card from the riser cage.
a. Loosen the two screws that secure the riser card.
b. Remove the riser card.
Figure 248. Removing the riser card
After this task is completed
• Install a replacement unit. See
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Remove drive backplanes
Procedure
Step 1. Disconnect all the cables from the backplanes.
Step 2. Loosen the four screws that secure Backplane 2; then, lift Backplane 2 to remove it.
"Install components to the left wing of riser assembly" on page
.
Chapter 5 Hardware replacement procedures
247.
235