Lenovo ThinkEdge SE360 V2 User Manual page 284

f. Power off the server and peripheral devices and disconnect the power cords and all external
cables. See
Step 2. Remove the following components in the sequence below.
a. Remove the top cover. See
b. Remove the PMB air baffle. See
c. Remove the riser assembly. (Before disconnecting the cables of riser assembly, remove the
processor air baffle.) See
"Remove the processor air baffle and air flow sensor board" on page
d. Depending on the model, remove the SMA assemblies or SMA fillers. See
assemblies" on page
e. Depending on the configuration, remove the power module board or internal power supply
unit. See "Remove the power module board (PMB)" on page 215
power supply unit (AC PMB)" on page
f. Remove the power input board (PIB) module. See
g. Remove the top intrusion switch with cable. See
on page 159.
h. Remove all the memory modules. See
i. If applicable, remove the wireless adapter. See
j. If applicable, remove the MicroSD card from the system board to install it onto the new system
board. See
Step 3. Disconnect all the cables from the system board. While disconnecting the cables, make a list of
each cable and record the connectors the cable is connected to, and use the record as a cabling
checklist after installing the new system board.
Step 4. Loosen the seven standoffs and two screws that secure the system board.
Note: Loosen the standoffs with a Phillips screwdriver or a flat-head screwdriver.
ThinkEdge SE360 V2 User Guide
274
"Power off the server" on page
"Remove the top cover" on page
"Remove the PMB air baffle" on page
"Remove the riser assembly from the node" on page 228
300.
"Remove the MicroSD card" on page
54.
197.
151.
"Remove the PIB module" on page
"Remove the top intrusion switch with cable"
"Remove a memory module" on page
"Remove the wireless adapter" on page
194.
107.
and
110.
"Remove the SMA
or "Remove the internal
211.
187.
285.