Lenovo ThinkEdge SE360 V2 User Manual page 223

About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Proceed to the section corresponding to the PIB module to be installed.
• "Install the DC PIB module" on page 213
• "Install the AC PIB module" on page 214
Install the DC PIB module
Procedure
Step 1. Insert the PIB module into the slot until it is firmly seated
Step 2. Secure the PIB module with one screw.
Figure 224. Installing the PIB module
After this task is completed
1. Reinstall the power module board. See
2. Complete the parts replacement. See
and "Safety inspection checklist" on page 48
"Install the power module board (PMB)" on page
"Complete the parts replacement" on page
Chapter 5
to ensure that you
218.
324.
.
Hardware replacement procedures
213