Siemens CU240B-2 Parameter Manual page 327

r3960[0...1] Control Unit temperature measured / CU temp measured
CU240E-2 Access level: 3
CU240E-2 DP
Can be changed: -
CU240E-2 DP F
Units group: -
CU240E-2 F
Min
- [°C]
Description: Displays the measured Control Unit temperature.
An appropriate message is output when 87 °C is exceeded.
Index: [0] = Temperature actual
[1] = Temperature maximum
Dependency: Refer to: A01009
Note: The value of -200 indicates that there is no measuring signal.
Re r3960[0]:
Displays the currently measured Control Unit temperature.
Re r3960[1]:
Displays the highest measured Control Unit temperature. This value is saved on the module in a non-volatile fash-
ion.
r3974 Drive unit status word / Drv_unit ZSW
Access level: 1
Can be changed: -
Units group: -
Min
-
Description: Displays the status word for the drive unit.
Bit field: Bit Signal name
00 Software reset active
01 Writing of parameters disabled as parame-
ter save in progress
02 Writing of parameters disabled as macro is
running
r3978 BICO CounterDevice / BICO CounterDevice
Access level: 4
Can be changed: -
Units group: -
Min
-
Description: Displays the counter reading for modified BICO interconnections on this device.
The counter is incremented by one for each modified BICO interconnection.
p3981 Faults, acknowledge drive object / Faults ackn DO
Access level: 3
Can be changed: U, T
Units group: -
Min
0
Description: Setting to acknowledge all active faults of a drive object.
Note: Parameter should be set from 0 to 1 to acknowledge.
After acknowledgement, the parameter is automatically reset to 0.
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Calculated: -
Scaling: p2006
Unit selection: -
Max
- [°C]
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Yes
Yes
Yes
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
1
Parameters
List of Parameters
Data type: FloatingPoint32
Data set: -
Factory setting
- [°C]
Data type: Unsigned32
Data set: -
Factory setting
-
0 signal
No
No
No
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: Unsigned8
Data set: -
Factory setting
0
FP
-
-
-
1-327