Siemens CU240B-2 Parameter Manual page 316

Parameters
List of Parameters
r2902[0...14] CO: Fixed values [%] / Fixed values [%]
Access level: 3
Can be changed: -
Units group: -
Min
- [%]
Description: Signal sources for frequently used percentage values.
Index: [0] = Fixed value +0 %
[1] = Fixed value +5 %
[2] = Fixed value +10 %
[3] = Fixed value +20 %
[4] = Fixed value +50 %
[5] = Fixed value +100 %
[6] = Fixed value +150 %
[7] = Fixed value +200 %
[8] = Fixed value -5 %
[9] = Fixed value -10 %
[10] = Fixed value -20 %
[11] = Fixed value -50 %
[12] = Fixed value -100 %
[13] = Fixed value -150%
[14] = Fixed value -200 %
Dependency: Refer to: p2900, p2901, p2930
Note: The signal sources can, for example, be used to interconnect scalings.
p2930[0...n] CO: Fixed value M [Nm] / Fixed value M [Nm]
Access level: 3
Can be changed: U, T
Units group: -
Min
-100000.00 [Nm]
Description: Sets a fixed value for torque.
Dependency: Refer to: p2900, p2901
Notice: A BICO interconnection to a parameter that belongs to a drive data set always acts on the effective data set.
Note: The value can, for example, be used to interconnect a supplementary torque.
p3110 External fault 3, power-up delay / Ext fault 3 t_on
Access level: 3
Can be changed: U, T
Units group: -
Min
0 [ms]
Description: Sets the delay time for external fault 3.
Dependency: Refer to: p2108, p3111, p3112
Refer to: F07862
1-316
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
- [%]
Calculated: -
Scaling: p2003
Unit selection: -
Max
100000.00 [Nm]
Calculated: -
Scaling: -
Unit selection: -
Max
1000 [ms]
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Data type: FloatingPoint32
Data set: -
Factory setting
- [%]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
0.00 [Nm]
Data type: Unsigned16
Data set: -
Factory setting
0 [ms]
© Siemens AG 2011 All Rights Reserved