Siemens CU240B-2 Parameter Manual page 124

Parameters
List of Parameters
r0949[0...63] Fault value / Fault value
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Displays additional information about the fault that occurred (as integer number).
Dependency: Refer to: r0945, r0947, r0948, r2109, r2130, r2133, r2136
Note: The buffer parameters are cyclically updated in the background (refer to status signal in r2139).
The structure of the fault buffer and the assignment of the indices is shown in r0945.
p0952 Fault cases, counter / Fault cases qty
Access level: 3
Can be changed: U, T
Units group: -
Min
0
Description: Number of fault situations that have occurred since the last reset.
Dependency: The fault buffer is deleted (cleared) by setting p0952 to 0.
Refer to: r0945, r0947, r0948, r0949, r2109, r2130, r2133, r2136
r0963 PROFIBUS baud rate / PB baud rate
CU240B-2 DP Access level: 3
CU240E-2 DP
Can be changed: -
CU240E-2 DP F
Units group: -
Min
0
Description: Displays the corresponding value for the PROFIBUS baud rate.
Value: 0:
1:
2:
3:
4:
6:
7:
8:
9:
10:
11:
255:
1-124
9.6 kbit/s
19.2 kbit/s
93.75 kbit/s
187.5 kbit/s
500 kbit/s
1.5 Mbit/s
3 Mbit/s
6 Mbit/s
12 Mbit/s
31.25 kbit/s
45.45 kbit/s
Baud rate unknown
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
65535
Calculated: -
Scaling: -
Unit selection: -
Max
255
Data type: Integer32
Data set: -
Factory setting
-
Data type: Unsigned16
Data set: -
Factory setting
0
Data type: Unsigned16
Data set: -
Factory setting
-
© Siemens AG 2011 All Rights Reserved