Siemens CU240B-2 Parameter Manual page 147

p1075[0...n] CI: Suppl setpoint / Suppl setpoint
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source for the supplementary setpoint.
Dependency: Refer to: p1076, r1077, r1078
p1076[0...n] CI: Supplementary setpoint scaling / Suppl setp scal
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source for scaling the supplementary setpoint.
r1077 CO: Supplementary setpoint effective / Suppl setpoint eff
Access level: 3
Can be changed: -
Units group: 3_1
Min
- [rpm]
Description: Displays the effective supplementary setpoint. The value shown is the additional setpoint after scaling.
r1078 CO: Total setpoint effective / Total setpoint eff
Access level: 3
Can be changed: -
Units group: 3_1
Min
- [rpm]
Description: Displays the total effective setpoint. The value indicates the sum of the effective main setpoint and supplementary
setpoint.
p1080[0...n] Minimum speed / n_min
Access level: 1
Can be changed: C(1), T
Units group: 3_1
Min
0.000 [rpm]
Description: Sets the lowest possible motor speed.
This value is not undershot in operation.
Note: The parameter value applies for both motor directions.
In exceptional cases, the motor can operate below this value (e.g. when reversing).
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Calculated: -
Scaling: p2000
Unit selection: -
Max
-
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: p2000
Unit selection: p0505
Max
- [rpm]
Calculated: -
Scaling: p2000
Unit selection: p0505
Max
- [rpm]
Calculated: -
Scaling: -
Unit selection: p0505
Max
19500.000 [rpm]
Parameters
List of Parameters
Data type: U32 / FloatingPoint32
Data set: CDS, p0170
Factory setting
0
Data type: U32 / FloatingPoint32
Data set: CDS, p0170
Factory setting
1
Data type: FloatingPoint32
Data set: -
Factory setting
- [rpm]
Data type: FloatingPoint32
Data set: -
Factory setting
- [rpm]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
0.000 [rpm]
1-147