Siemens CU240B-2 Parameter Manual page 219

r1583 Flux setpoint smoothed / Flux setp smooth
Access level: 4
Can be changed: -
Units group: -
Min
- [%]
Description: Displays the smoothed flux setpoint.
The value is referred to the rated motor flux.
p1584[0...n] Field weakening operation, flux setpoint smoothing time / Field weak T_smth
Access level: 4
Can be changed: U, T
Units group: -
Min
0 [ms]
Description: Sets the smoothing time for the flux setpoint in the field-weakening range
Note: Only the flux setpoint rise is smoothed
r1589 Field-weakening current, pre-control value / I_FieldWeak prectr
Access level: 4
Can be changed: -
Units group: 6_2
Min
- [Arms]
Description: Displays the pre-control value for the field weakening current.
r1593[0...1] CO: Field weakening controller / flux controller output / Field/Fl_ctrl outp
Access level: 4
Can be changed: -
Units group: 6_2
Min
- [Arms]
Description: Displays the output of the field weakening controller (synchronous motor).
Index: [0] = PI output
[1] = I output
p1594[0...n] Field-weakening controller, P gain / Field_ctrl Kp
Access level: 4
Can be changed: U, T
Units group: -
Min
0.00
Description: Sets the P gain of the field-weakening controller.
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
- [%]
Calculated: p0340 = 1,3
Scaling: -
Unit selection: -
Max
20000 [ms]
Calculated: -
Scaling: p2002
Unit selection: p0505
Max
- [Arms]
Calculated: -
Scaling: p2002
Unit selection: p0505
Max
- [Arms]
Calculated: -
Scaling: -
Unit selection: -
Max
1000.00
Parameters
List of Parameters
Data type: FloatingPoint32
Data set: -
Factory setting
- [%]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
0 [ms]
Data type: FloatingPoint32
Data set: -
Factory setting
- [Arms]
Data type: FloatingPoint32
Data set: -
Factory setting
- [Arms]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
0.00
1-219