Siemens CU240B-2 Parameter Manual page 294

Parameters
List of Parameters
p2188[0...n] Load monitoring torque threshold 2, lower / M_thresh 2 lower
Access level: 3
Can be changed: U, T
Units group: 7_1
Min
0.00 [Nm]
Description: Sets the speed/torque envelope curve for load monitoring.
Dependency: The following applies: p2188 < p2187
Refer to: p2183, p2187
Note: The lower envelope curve is defined by p2186, p2188 and p2190.
p2189[0...n] Load monitoring torque threshold 3, upper / M_thresh 3 upper
Access level: 3
Can be changed: U, T
Units group: 7_1
Min
0.00 [Nm]
Description: Sets the speed/torque envelope curve for load monitoring.
Dependency: The following applies: p2189 > p2190
Refer to: p2184, p2190
Note: The upper envelope curve is defined by p2185, p2187 and p2189.
p2190[0...n] Load monitoring torque threshold 3, lower / M_thresh 3 lower
Access level: 3
Can be changed: U, T
Units group: 7_1
Min
0.00 [Nm]
Description: Sets the speed/torque envelope curve for load monitoring.
Dependency: The following applies: p2190 < p2189
Refer to: p2184, p2189
Note: The lower envelope curve is defined by p2186, p2188 and p2190.
p2192[0...n] Load monitoring delay time / Load monit t_del
Access level: 3
Can be changed: U, T
Units group: -
Min
0.00 [s]
Description: Sets the delay time to evaluate the load monitoring.
1-294
Calculated: -
Scaling: -
Unit selection: p0505
Max
20000000.00 [Nm]
Calculated: -
Scaling: -
Unit selection: p0505
Max
20000000.00 [Nm]
Calculated: -
Scaling: -
Unit selection: p0505
Max
20000000.00 [Nm]
Calculated: -
Scaling: -
Unit selection: -
Max
65.00 [s]
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
0.00 [Nm]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
10000000.00 [Nm]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
0.00 [Nm]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
10.00 [s]
© Siemens AG 2011 All Rights Reserved