Siemens CU240B-2 Parameter Manual page 102
Hide thumbs
Also See for CU240B-2:
- Operating instructions manual (36 pages) ,
- Compact operating instructions (32 pages)
Table of Contents
Advertisement
Parameters
List of Parameters
p0779[0...1]
CU analog outputs characteristic value x2 / CU char x2
Access level: 2
Can be changed: U, T
Units group: -
Min
-1000.00 [%]
Description:
Sets the scaling characteristic for the analog outputs.
The scaling characteristic for the analog outputs is defined using 2 points.
This parameter specifies the x coordinate (percentage) of the 2nd value pair of the characteristic.
Index:
[0] = AO0 (T 12/13)
[1] = AO1 (T 26/27)
Dependency:
Refer to: p0776
Notice:
This parameter is automatically overwritten when the analog output type is changed (p0776).
Note:
This parameter is automatically overwritten if p0776 (type of analog output) is changed.
The parameters for the characteristic do not have a limiting effect.
p0780[0...1]
CU analog outputs characteristic value y2 / CU char y2
Access level: 2
Can be changed: U, T
Units group: -
Min
-20.000 [V]
Description:
Sets the scaling characteristic for the analog outputs.
The scaling characteristic for the analog outputs is defined using 2 points.
This parameter specifies the y coordinate (output voltage in V or output current in mA) of the 2nd value pair of the
characteristic.
Index:
[0] = AO0 (T 12/13)
[1] = AO1 (T 26/27)
Dependency:
The unit of this parameter (V or mA) depends on the analog input type.
Refer to: p0776
Notice:
This parameter is automatically overwritten when the analog output type is changed (p0776).
Note:
This parameter is automatically overwritten if p0776 (type of analog output) is changed.
The parameters for the characteristic do not have a limiting effect.
p0782[0...1]
BI: CU analog outputs invert signal source / CU AO inv S_src
Access level: 3
Can be changed: U, T
Units group: -
Min
-
Description:
Sets the signal source to invert the analog output signals.
Index:
[0] = AO0 (T 12/13)
[1] = AO1 (T 26/27)
Note:
AO: Analog Output
T: Terminal
1-102
Calculated: -
Scaling: -
Unit selection: -
Max
1000.00 [%]
Calculated: -
Scaling: -
Unit selection: -
Max
20.000 [V]
Calculated: -
Scaling: -
Unit selection: -
Max
-
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Data type: FloatingPoint32
Data set: -
Factory setting
100.00 [%]
Data type: FloatingPoint32
Data set: -
Factory setting
20.000 [V]
Data type: U32 / Binary
Data set: -
Factory setting
0
© Siemens AG 2011 All Rights Reserved
Hide quick links:
Advertisement
Table of Contents
