Siemens CU240B-2 Parameter Manual page 95

r0747 CU, digital outputs status / CU DO status
CU240E-2 Access level: 3
CU240E-2 DP
Can be changed: -
CU240E-2 DP F
Units group: -
CU240E-2 F
Min
-
Description: Displays the status of digital outputs.
Bit field: Bit Signal name
00 DO 0 (NO: T. 19 / NC: T. 18)
01 DO 1 (NO: T. 21)
02 DO 2 (NO: T. 24 / NC: T. 23)
Note: DO: Digital Output
T: Terminal
Relay output: NO = normally open, NC = normally closed
Inversion using p0748 has been taken into account.
p0748 CU, invert digital outputs / CU DO inv
CU240B-2 Access level: 3
CU240B-2 DP
Can be changed: U, T
Units group: -
Min
-
Description: Setting to invert the signals at the digital outputs.
Bit field: Bit Signal name
00 DO 0 (NO: T. 19 / NC: T. 18)
Note: DO: Digital Output
T: Terminal
Relay output: NO = normally open, NC = normally closed
p0748 CU, invert digital outputs / CU DO inv
CU240E-2 Access level: 3
CU240E-2 DP
Can be changed: U, T
CU240E-2 DP F
Units group: -
CU240E-2 F
Min
-
Description: Setting to invert the signals at the digital outputs.
Bit field: Bit Signal name
00 DO 0 (NO: T. 19 / NC: T. 18)
01 DO 1 (NO: T. 21)
02 DO 2 (NO: T. 24 / NC: T. 23)
Note: DO: Digital Output
T: Terminal
Relay output: NO = normally open, NC = normally closed
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
High
High
High
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Inverted
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Inverted
Inverted
Inverted
Parameters
List of Parameters
Data type: Unsigned32
Data set: -
Factory setting
-
0 signal
Low
Low
Low
Data type: Unsigned32
Data set: -
Factory setting
0000 bin
0 signal
Not inverted
Data type: Unsigned32
Data set: -
Factory setting
0000 bin
0 signal
Not inverted
Not inverted
Not inverted
FP
-
-
-
FP
-
FP
-
-
-
1-95