Siemens CU240B-2 Parameter Manual page 458

Parameters
List of Parameters
p20354 BI: MFP 2 input pulse I / MFP 2 inp_pulse I
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source for the input pulse I of instance MFP 2 of the pulse generator.
p20355 MFP 2 pulse duration in ms / MFP 2 pulse_dur ms
Access level: 3
Can be changed: T
Units group: -
Min
0.00
Description: Setting parameter for pulse duration T in milliseconds of instance MFP 2 of the pulse generator.
r20356 BO: MFP 2 output Q / MFP 2 output Q
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for output pulse Q of instance MFP 2 of the pulse generator.
p20357 MFP 2 run-time group / MFP 2 RTG
Access level: 3
Can be changed: T
Units group: -
Min
5
Description: Setting parameter for the run-time group in which the instance MFP 2 of the pulse generator is to be called.
Value: 5:
6:
9999: Do not calculate
p20358 MFP 2 run sequence / MFP 2 RunSeq
Access level: 3
Can be changed: T
Units group: -
Min
0
Description: Setting parameter for the run sequence of instance MFP 2 within the run-time group set in p20357.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
1-458
Run-time group 5
Run-time group 6
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
60000.00
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
9999
Calculated: -
Scaling: -
Unit selection: -
Max
32000
Data type: U32 / Binary
Data set: -
Factory setting
0
Data type: FloatingPoint32
Data set: -
Factory setting
0.00
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: Integer16
Data set: -
Factory setting
9999
Data type: Unsigned16
Data set: -
Factory setting
950
© Siemens AG 2011 All Rights Reserved