Siemens CU240B-2 Parameter Manual page 451

r20319 BO: NCM 1 output QU / NCM 1 output QU
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for binary quantity QU of instance NCM 1 of the numeric comparator.
QU is only set if X0 > X1.
r20320 BO: NCM 1 output QE / NCM 1 output QE
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for binary quantity QE of instance NCM 1 of the numeric comparator.
QE is only set if X0 = X1.
r20321 BO: NCM 1 output QL / NCM 1 output QL
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for binary quantity QL of instance NCM 1 of the numeric comparator.
QL is only set if X0 < X1.
p20322 NCM 1 run-time group / NCM 1 RTG
Access level: 3
Can be changed: T
Units group: -
Min
5
Description: Setting parameter for the run-time group in which the instance NCM 1 of the numeric comparator is to be called.
Value: 5:
6:
9999: Do not calculate
p20323 NCM 1 run sequence / NCM 1 RunSeq
Access level: 3
Can be changed: T
Units group: -
Min
0
Description: Setting parameter for the run sequence of instance NCM 1 within the run-time group set in p20322.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Run-time group 5
Run-time group 6
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
9999
Calculated: -
Scaling: -
Unit selection: -
Max
32000
Parameters
List of Parameters
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: Integer16
Data set: -
Factory setting
9999
Data type: Unsigned16
Data set: -
Factory setting
830
1-451