Siemens CU240B-2 Parameter Manual page 355

p9566 SI Motion SDI stop response (processor 1) / SI Mtn SDI Stop P1
CU240E-2 DP F Access level: 3
CU240E-2 F
Can be changed: C(95)
Units group: -
Min
0
Description: Sets the stop response for the function "Safe motion direction" (SDI).
This setting applies to both directions of motion.
Value: 0:
1:
Dependency: Refer to: p9564, p9565
Refer to: C01716
Note: SDI: Safe Direction (safe motion direction)
p9568 SI Motion SAM velocity limit (processor 1) / SI Mtn SAM v_limP1
Access level: 3
CU240E-2 DP F
Can be changed: C(95)
CU240E-2 F
Units group: -
Min
0.00 [rpm]
Description: Sets the velocity tolerance limit for the "SAM" function.
SAM is de-activated once the set velocity limit has been undershot.
Note: SAM: Safe Acceleration Monitor (safe acceleration monitoring)
SSM: Safe Speed Monitor (safety-relevant feedback signal from the velocity monitoring)
For p9568 = p9368 = 0, the following applies:
The value in p9546/p9346 (SSM) is applied as the velocity limit for SAM.
p9570 SI Motion acceptance test mode (processor 1) / SI Mtn acc_mod P1
CU240E-2 DP F Access level: 3
CU240E-2 F
Can be changed: U, T
Units group: -
Min
0000 hex
Description: Setting to select and de-select the acceptance test mode.
Value: 0:
172:
Dependency: Refer to: p9558, r9571, p9601
Refer to: C01799
Note: Acceptance test mode can only be selected if the motion monitoring functions, which are integrated in the drives,
are enabled (p9601.2/p9801.2).
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
STOP A
STOP B
[00 hex] De-select the acceptance test mode
[AC hex] Select the acceptance test mode
Calculated: -
Scaling: -
Unit selection: -
Max
1
Calculated: -
Scaling: -
Unit selection: -
Max
1000.00 [rpm]
Calculated: -
Scaling: -
Unit selection: -
Max
00AC hex
Parameters
List of Parameters
Data type: Integer16
Data set: -
Factory setting
1
Data type: FloatingPoint32
Data set: -
Factory setting
0.00 [rpm]
Data type: Integer16
Data set: -
Factory setting
0000 hex
1-355