Siemens CU240B-2 Parameter Manual page 420

Parameters
List of Parameters
p20149 PCL 0 pulse duration in ms / PCL 0 pulse_dur ms
Access level: 3
Can be changed: T
Units group: -
Min
0.00
Description: Setting parameter for pulse duration T in milliseconds of instance PCL 0 of the pulse shortener.
r20150 BO: PCL 0 output Q / PCL 0 output Q
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for output pulse Q of instance PCL 0 of the pulse shortener.
p20151 PCL 0 run-time group / PCL 0 RTG
Access level: 3
Can be changed: T
Units group: -
Min
5
Description: Setting parameter for the run-time group in which the instance PCL 0 of the pulse shortener is to be called.
Value: 5:
6:
9999: Do not calculate
p20152 PCL 0 run sequence / PCL 0 RunSeq
Access level: 3
Can be changed: T
Units group: -
Min
0
Description: Setting parameter for the run sequence of instance PCL 0 within the run-time group set in p20151.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20153 BI: PCL 1 input pulse I / PCL 1 inp_pulse I
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source for the input pulse I of instance PCL 1 of the pulse shortener.
1-420
Run-time group 5
Run-time group 6
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
60000.00
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
9999
Calculated: -
Scaling: -
Unit selection: -
Max
32000
Calculated: -
Scaling: -
Unit selection: -
Max
-
Data type: FloatingPoint32
Data set: -
Factory setting
0.00
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: Integer16
Data set: -
Factory setting
9999
Data type: Unsigned16
Data set: -
Factory setting
400
Data type: U32 / Binary
Data set: -
Factory setting
0
© Siemens AG 2011 All Rights Reserved