Siemens CU240B-2 Parameter Manual page 146

Parameters
List of Parameters
p1070[0...n] CI: Main setpoint / Main setpoint
CU240B-2 Access level: 3
CU240E-2
Can be changed: T
CU240E-2 F
Units group: -
Min
-
Description: Sets the signal source for the main setpoint.
Examples:
r1024: Fixed speed setpoint effective
r1050: Motor. potentiometer setpoint after the ramp-function generator
Dependency: Refer to: p1071, r1073, r1078
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
p1070[0...n] CI: Main setpoint / Main setpoint
CU240B-2 DP Access level: 3
CU240E-2 DP
Can be changed: T
CU240E-2 DP F
Units group: -
Min
-
Description: Sets the signal source for the main setpoint.
Examples:
r1024: Fixed speed setpoint effective
r1050: Motor. potentiometer setpoint after the ramp-function generator
Dependency: Refer to: p1071, r1073, r1078
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
p1071[0...n] CI: Main setpoint scaling / Main setp scal
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source for scaling the main setpoint.
r1073 CO: Main setpoint effective / Main setpoint eff
Access level: 3
Can be changed: -
Units group: 3_1
Min
- [rpm]
Description: Displays the effective main setpoint. The value shown is the main setpoint after scaling.
1-146
Calculated: -
Scaling: p2000
Unit selection: -
Max
-
Calculated: -
Scaling: p2000
Unit selection: -
Max
-
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: p2000
Unit selection: p0505
Max
- [rpm]
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Data type: U32 / FloatingPoint32
Data set: CDS, p0170
Factory setting
[0] 755[0]
[1] 0
[2] 0
[3] 0
Data type: U32 / FloatingPoint32
Data set: CDS, p0170
Factory setting
[0] 2050[1]
[1] 0
[2] 0
[3] 0
Data type: U32 / FloatingPoint32
Data set: CDS, p0170
Factory setting
1
Data type: FloatingPoint32
Data set: -
Factory setting
- [rpm]
© Siemens AG 2011 All Rights Reserved