Siemens CU240B-2 Parameter Manual page 383

r9976[0...7] System utilization / Sys util
Access level: 3
Can be changed: -
Units group: -
Min
- [%]
Description: Displays the system utilization.
If the utilization is greater than 100%, fault F01054 is output.
Index: [0] = Reserved
[1] = Computing time utilization
[2] = Reserved
[3] = Reserved
[4] = Reserved
[5] = Largest total utilization
[6] = Reserved
[7] = Reserved
Dependency: Refer to: F01205
Note: Re index 1:
The value shows the total computing time load of the system.
Re index 5:
The total utilization is determined using all sampling times used. The largest total utilization is mapped here. The
sampling time with the largest total utilization is displayed in r9979.
Total utilization:
Computing time load of sampling time involved including load from higher-priority sampling times (interrupts).
r9999[0...99] Software error internal supplementary diagnostics / SW_err int diag
Access level: 4
Can be changed: -
Units group: -
Min
-
Description: Diagnostics parameter to display additional information for internal software errors.
Note: Only for internal Siemens troubleshooting.
p10002 SI discrepancy monitoring time (processor 1) / SI discrp t_mon P1
CU240E-2 DP F Access level: 3
CU240E-2 F
Can be changed: C(95)
Units group: -
Min
1.00 [ms]
Description: Sets the monitoring time for the discrepancy for the digital inputs.
The signal states at the two associated digital inputs (F-DI) must assume the same state within this monitoring time.
Dependency: Refer to: p10102
Note: F-DI: Failsafe Digital Input
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
- [%]
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
2000.00 [ms]
Parameters
List of Parameters
Data type: FloatingPoint32
Data set: -
Factory setting
- [%]
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: FloatingPoint32
Data set: -
Factory setting
500.00 [ms]
1-383