Wiring
4.7 Overview of the converter interfaces
4.7
Overview of the converter interfaces
A G115D converter consists of an Electronic Module and a Wiring Module.
The converter is equipped with plug-in sockets and/or blanking caps (for wiring with cable
glands) when delivered, depending on the variant, i.e. connector variant or glanded variant,
that has been ordered.
For the connector variant, the converter is all wired up internally when delivered and all that
is required is the external wiring of the system. For the glanded variant, make sure you wire
the terminals and route the cables inside the Wiring Module and fix with the cable glands.
Note that the converters of glanded variant provide no cable glands but blanking caps at
delivery for all glanded interfaces.
52
Operating Instructions, 09/2020, FW V4.7 SP13, A5E48681219B
SINAMICS G115D distributed drive