Siemens SINAMICS G115D Operating Instructions Manual page 142

Advanced commissioning
6.6 Drive control via Ethernet/IP
No.
3
4
5
6
10
140
Service Type Name
get ARRAY Physical Address
get_and_ Struct of Interface Counters
clear
UINT32 In Octets
UINT32 In Ucast Packets
UINT32 In NUcast Packets
UINT32 In Discards
UINT32 In Errors
UINT32 In Unknown Protos
UINT32 Out Octets
UINT32 Out Ucast Packets
UINT32 Out NUcast packets
UINT32 Out Discards
UINT32 Out Errors
get_and_ Struct of Media Counters
clear
UINT32 Alignment Errors
UINT32 FCS Errors
UINT32 Single Collisions
UINT32 Multiple Collisions
UINT32 SQE Test Errors
UINT32 Deferred Transmis-
sions
UINT32 Late Collisions
UINT32 Excessive Collisions
UINT32 MAC Transmit Errors
UINT32 Carrier Sense Errors
UINT32 Frame Too Long
UINT32 MAC Receive Errors
get, set Struct of Interface Control
UINT16 Control Bits
UINT16 Forced Interface
Speed
get String Interface_Label
Value/explanation
r8935 Ethernet MAC address
Optional, required if the "Media Counters Attrib-
ute" is implemented.
Received octets
Received Unicast packets
Received non-Unicast packets
Incoming packets, not processed
Incoming packets with errors
Incoming packets with unknown protocol
Sent octets
Sent Unicast packets
Sent non-Unicast packets
Outgoing packets, not processed
Outgoing packets, with errors
Media-specific counters
Structure received, which does not match the
number of octets
Structure received, which does not pass the FCS
check
Structure successfully transmitted, precisely one
collision
Structure successfully transmitted, several colli-
sions
Number of SQE errors
First transmission attempt delayed
Number of collisions that occurred delayed by
512 bit timers to the request
Transmission unsuccessful as a result of inten-
sive collisions
Transmission unsuccessful as a result of an in-
ternal MAC sublayer transmission error.
Times that the carrier sense condition was lost
or never asserted when attempting to transmit a
frame
Structure too large
Transmission unsuccessful as a result of an in-
ternal MAC sublayer receive error.
Interface-Label
Operating Instructions, 09/2020, FW V4.7 SP13, A5E48681219B
SINAMICS G115D distributed drive