Siemens SINAMICS G115D Operating Instructions Manual page 180

Advanced commissioning
6.9 Switching over the drive control (command data set)
Copying command data sets
1. Set p0809[0] to the number of the command data set whose settings you wish to copy
(source).
2. Set p0809[1] to the number of the command data set in which you wish to copy the
settings.
3. Set p0809[2] = 1 to start the copying.
4. The converter sets p0809[2] = 0 after the copying finishes.
You have copied the settings of a command data set into another command data set.
❒
Example
As in the example above, you obtain the interconnection if you configured the interfaces of
the converter accordingly.
An overview of all the parameters that belong to the command data sets is provided in the
List Manual.
Note
The converter requires approximately 4 ms to switch over the command data set.
178
Operating Instructions, 09/2020, FW V4.7 SP13, A5E48681219B
SINAMICS G115D distributed drive