Siemens SINAMICS G115D Operating Instructions Manual page 423

Note
Apply a thin layer of grease to the shrink disk seat on the hollow shaft.
Note
Coat with a suitable lubricant to prevent frictional corrosion of the contact surface on the
customer's machine shaft in the vicinity of the bushing.
Sizes 19 - 69
a
b
①
②
③
④
⑤
⑥
Figure 11-21 Mounting the shrink disk
Procedure
1. Push the shrink disk ③ onto the hollow shaft ②.
– 3-part shrink disk up to the end stop for sizes 19 - 69.
– 2-part shrink disk flush with the shaft end for sizes 79 - 89.
2. Tighten the clamping bolts ⑥, initially by hand. Align the shrink disk ③ so that the clamping
flanges are plane-parallel with one other.
3. Use the torque wrench to turn each of the clamping bolts ⑥ equally by 1/6 revolution (not
crosswise); repeat this procedure several times. Observe the tightening torque.
4. Attach the rubber cover or protection cover included in the scope of supply, see Removing
and installing the protection cover (Page 414).
You have now installed the shrink disk.
SINAMICS G115D distributed drive
Operating Instructions, 09/2020, FW V4.7 SP13, A5E48681219B
Greased
Absolutely grease-free
Machine shaft
Hollow shaft
Shrink disk comprising items ④ - ⑥
Outer ring
Inner ring
Clamping bolt
Additional information on the SIMOGEAR geared motor
Sizes 79 - 89
11.3 Specific data gearbox
421