Siemens SINAMICS G115D Operating Instructions Manual page 207

Parameters
Table 6- 23
Parameter
p1035[0...n]
p1036[0...n]
p1040[0...n]
p1047
p1048
r1050
p1070[0...n]
p1071[0...n]
r1073
p1075[0...n]
p1076[0...n]
r1077
SINAMICS G115D distributed drive
Operating Instructions, 09/2020, FW V4.7 SP13, A5E48681219B
Basic settings
Description
BI: Motorized potentiometer set-
point higher
BI: Motorized potentiometer set-
point lower
Motorized potentiometer start
value [rpm]
Motorized potentiometer, ramp-
up time [s]
Motorized potentiometer, ramp-
down time [s]
Motorized potentiometer, setpoint
after the ramp-function generator
CI: Main setpoint
CI: Main setpoint scaling
CO: Main setpoint active
CI: Supplementary setpoint
CI: Supplementary setpoint scaling Signal source for scaling the supplementary set-
CO: Supplementary setpoint effec-
tive [rpm]
Advanced commissioning
Setting
Signal source to continuously increase the set-
point
The factory setting depends on the converter.
• With PROFINET interface: [0] 2090.13; [1] 0
• Without PROFINET interface: 0
Signal source to continuously decrease the set-
point
The factory setting depends on the converter.
• With PROFINET interface: [0] 2090.14; [1] 0
• Without PROFINET interface: 0
Start value that is effective when the motor is
switched on.
Factory setting: 0 rpm
MOP ramp-up time
Factory setting: 10 s
MOP ramp-down time
Factory setting: 10 s
Motorized potentiometer, setpoint after the
ramp-function generator
Signal source for the main setpoint
The factory setting depends on the converter.
• With PROFINET interface: [0] 2050[1]
• Without PROFINET interface: [0] 755[0]
Signal source for scaling the main setpoint
Factory setting: 1
Displays the active main setpoint
Signal source for the supplementary setpoint
Factory setting: 0
point
Factory setting: 0
Displays the effective supplementary setpoint.
The value shown is the additional setpoint after
scaling.
6.14 Setpoints
205