Siemens SINAMICS G115D Operating Instructions Manual page 141

No.
2
3
4
5
6
10
11
Link Object, Instance Number: F6 hex
Supported services
Class
Table 6- 20
No.
1
2
3
Table 6- 21
No.
1
2
SINAMICS G115D distributed drive
Operating Instructions, 09/2020, FW V4.7 SP13, A5E48681219B
Service Type Name
get UNIT32 Configuration
Capability
get, set UNIT32 Configuration
Control
get UNIT16 Path Size (in
WORDs)
UNIT8 Path
get, set STRING Interface Config-
uration
UNIT32
get, set UNIT16 Host Name
STRING
get, set UNIT8 Select ACD
get, set UNIT8 Last Conflict
Detected
UNIT8
UNIT8
• Get Attribute all
• Get Attribute single
Class Attribute
Service Type
get UINT16
get UINT16
get UINT16
Instance Attribute
Service Type Name
get UINT32 Interface Speed
get Interface Flags
Value/explanation
Fixed value: 94 hex
4 hex: DHCP supported,
10 hex: Configuration can be adjusted,
80 hex: ACD-capable
1 hex: Saved values
3 hex: DHCP
Fixed value: 2 hex
20 hex,
F6 hex,
24 hex,
05 hex, where 5 hex is the number of instances of
F6 hex (four physical ports plus one internal port).
r61000 Name of Station
r61001 IP address
Host Name Length
local OM flash:
0: Disabled,
1: Enabled
local OM flash ACD Activity
local OM flash Remote MAC
local OM flash ARP PDU
Instance
Name
Revision
Max Instance
Num of Instances
Value/explanation
0: link down,
10: 10 Mbps,
100: 100 Mbps
Bit 1: Link-Status
Bit 2: Duplex Mode (0: halb duplex, 1 duplex
Bit 3 ... 5: Automatic state identification
Bit 6: Reset required
Bit 7: Local hardware fault (0 = ok)
Advanced commissioning
6.6 Drive control via Ethernet/IP
• Get Attribute all
• Get Attribute single
• Set Attribute single
139