General Information Concerning The Installation - Siemens SINAMICS G115D Operating Instructions Manual

11.1.10

General information concerning the installation

Assembly work with the system under load
Under load, the system can start or reverse in an uncontrolled fashion.
The entire system must be load-free so that there is no danger during this work.
NOTICE
Destruction caused by welding
Welding destroys the geared parts and bearings.
Do not weld on the gearbox. The gearbox must not be used as a grounding point for
welding operations.
NOTICE
Overheating caused by solar radiation
Overheating of the geared motor due to exposure to direct sunlight.
Provide suitable protective equipment such as covers or roofs. Prevent heat accumulation.
NOTICE
Malfunction resulting from foreign objects
The operator must ensure that no foreign objects impair the function of the gearbox.
NOTICE
Damaged components impair the correct function of the gearbox
If any components are damaged, the correct function of the gearbox will no longer be
ensured.
Do not install any damaged gearbox components.
NOTICE
Violation of the maximum permissible oil sump temperature
The oil sump temperature will be exceeded if the temperature monitoring equipment is
incorrectly set.
An alarm must be output when the maximum permissible oil sump temperature is reached.
The geared motor must be switched off when the maximum permissible temperature is
exceeded. The machine will come to a standstill if the geared motor is shut down.
Note
Use headless screws with property class 8.8 or higher to fasten the motor.
SINAMICS G115D distributed drive
Operating Instructions, 09/2020, FW V4.7 SP13, A5E48681219B
WARNING
Additional information on the SIMOGEAR geared motor
11.1 General information geared motor
361