Parameters
You can commission the conveyor technology functions via the Startdrive PC tool.
6.8.5
Conveyor technology control parameters
Parameter
r0722.0...25
p1070[0...n]
p1071[0...n]
p1075[0...n]
p1076[0...n]
SINAMICS G115D distributed drive
Operating Instructions, 09/2020, FW V4.7 SP13, A5E48681219B
Conveyor technology control parameters (Page 175)
Description
CO/BO: Digital inputs status
CI: Main setpoint
CI: Main setpoint scaling
CI: Supplementary setpoint
CI: Supplementary setpoint scaling Sets the signal source for scaling the supplemen-
Advanced commissioning
6.8 Conveyor technology control functions
Setting
Interconnect the signals of the sensors to the
digital inputs as desired.
Sets the signal source for the main setpoint.
Sets the signal source for scaling the main set-
point.
Factory setting: 1
Sets the signal source for the supplementary
setpoint. Note that the supplementary setpoint
adds to both p3397 and p3398
tary setpoint.
Factory setting: 1
175