Table of Contents
Advertisement
Figure 40: MX2010 AC Power Supply Module Front View
NOTE: Each PSM slot not occupied by an AC PSM must be covered by a PSM blank panel.
Connect Power to a DC Power Distribution Module
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis. For more information about ESD, see the
Routing Platform Hardware
NOTE: If the DC PSMs are installed in the router, make sure the power switch is turned to
the off (O) position.
2.
Ensure that the voltage across the DC power source cable leads is 0 V and that there is no chance
that the cable leads might become active during installation.
3.
Remove the DC PDM from the electrostatic bag.
4.
Using both hands, slide the PDM part way into the chassis.
5.
Open the two locking levers on either side of the PDM, and align them with the openings in the
chassis.
Guide.
MX2010 Universal
71
Advertisement
Table of Contents
