Installing A T4000-Sib; Figure 132: Removing A T4000 Sib - Juniper T4000 Hardware Manual

T4000 Core Router Hardware Guide

Installing a T4000-SIB

320

Figure 132: Removing a T4000 SIB

To install a T4000-SIB (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place one hand underneath the SIB to support it. With the other hand, hold one of the
2.
ejector handles on the SIB.
Carefully align the sides of the SIB with the guides inside the chassis.
3.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
4.
Grasp both ejector handles, and press them inward to seat the SIB. Ensure that the
5.
ejector handle tabs are properly mated inside their corresponding chassis slots. You
might have to close and open the handles a few times before the tabs catch the slots.
Tighten the captive screws on the ejector handles.
6.
Bring the SIB online using one of the following methods:
7.
Press and hold the
ONLINE/OFFLINE
LED on the faceplate begins to blink. Hold the button down until the LED blinks.
Figure 133 on page 321):
button on the SIB faceplate. The green
Copyright © 2018, Juniper Networks, Inc.
OK